Attopsemi Technology Presented "I-fuse: Dream OTP Finally Comes True" and won the best Innovative IP award on IP SoC 2019 China

Hsinchu, Taiwan –September 18, 2019 – Attopsemi Technology attended D&R IP SoC Day on September 12, 2019 in Shanghai, China and provided a talk “I-fuse™: Dream OTP Finally Comes True” and won the best Innovative IP award.

In a well-received speech during the Technical Session, Shine Chung, Chairman of Attopsemi, presented the topic “I-fuse™: Dream OTP Finally Comes True” In the OTP(One-Time Programmable) IP market. Defying the conventional wisdom of breaking a fuse to maintain a permanent programmed state forever, Attopsemi’s I-fuse™ is actually a “non-breaking” fuse. “I don’t mind to break a fuse, but I do care about breaking a fuse by explosion”, said Shine Chung, Chairman of Attopsemi. “The I-V curve of programming a fuse after the break point actually show the behavior is more like an explosion. The SEM photos do confirm this. After explosion, debris can be created and micro-bridged again and become shorts to cause severe reliability problems.” “On the other hand, the I-V curves showed very smooth and repeatable curves, if the programming is below the break point and above the electromigration threshold,” further explained by Shine Chung.

With a twist of mindset, all the good attributes of an OTP show up. Program current/voltage can be lower. Cell/IP size can be smaller. High temperature, high reliability, and high data security can be achieved because of less damage to the fuse body. The program voltage can be inlined with I/O voltages, or can even be core voltages with some area penalties. In fact, I-fuse™ is more like a logic device that can be read at sub-VDD and consume only 1/100 of read energy, comparing with the conventional sensing, for energy harvest. I-fuse™ can also be built as bit cell in any standard cell libraries so that low-bit-count I-fuse™ OTP can be built by standard logic design flow.

Comparing with the other OTP technologies on 22nm and beyond, I-fuse™ can be programmed at 1.0V, while the other anti-fuses need 4-5V to program. I-fuse™ can be programmed at 1.0mA, while the eFuse needs up to 100mA to program.

A dream OTP, I-fuse™, finally comes true.

Dream OTP Finally Comes True.

Shine Chung, Chairman of Attopsemi (left) Presented “I-fuse™: Dream OTP Finally Comes True” and won the best IP prize in IP SoC 2019 China.

https://www.design-reuse-embedded.com/ipsocdays/ipsocdays2019/china2019/files/bio/BestPrize.jsp

About Attopsemi Technology

Founded in 2010, Attopsemi Technology is dedicated to developing and licensing fuse-based One-Time Programmable (OTP) IP to all CMOS process technologies from 0.7um to 7nm and beyond in various silicided polysilicon, HKMG, FDSOI and FinFET technologies. Attopsemi provides the best possible OTP solutions for all merits in small size, low voltage/current programming/read, high quality, high reliability, low power, high speed, wide temperature and high data security. Attopsemi's proprietary I-fuse™ OTP technologies have been proven in numerous CMOS technologies and in several silicon foundries.

 Back